Comtrend Corporation PowerGrid 902 User's Guide download pdf (Page 8)

How to add a new Powerline to your existing network

Comtrend Powerline pairs are paired in the factory for your convenience

and security. However if you need to add more adapters to your existing

network you will need to follow some easy steps in order to keep your

network secure. The following procedure applies to both Powerline

DH10PF and PG902 adapters.

MAKE SURE THAT ALL OF YOUR POWERLINES ARE CONNECTED

TO THE MAINS.

Step 1: Identify the current AP

(access point) adapter. From your

current adapters the one with the

AP LED in green will be the AP

adapter.

NOTE: If you performed a factory reset on the AP adapter (see step 2), it

is now an EP adapter. In this case, you will need to assign it as an

AP (see FAQ on pg. 9).

Step 2: Reset the new Adapter to its

factory settings: this is to make sure your

new adapter is set as an EP (end point).

Press the CONFIG/RESET button for

10 seconds. All LEDs will turn OFF and

the STATUS LED will be RED.

AP/ STBY

ETHERN ET

STATUS

CON FIG

RES ET

ST BY

Power line Eth ernet

Adapt er with Fi lter

AP/ STBY

ET HERNET

STATUS

CONFIG

RESET

ST BY

Powe rline Ethernet

Adap ter with Fi lter

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Comtrend Corporation PowerGrid 902 User's Guide Page 8