Comtrend Corporation Powerline PowerGrid DH-10P User Manual Page 5
- Page / 16
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
DH10PF User Manual
Design of Systems on Silicon PAGE 5 OF 16
MG-TI-C2-WISC-DH10PF USER INTERFACE MANUAL-1.1
1 Introduction
The scope of this document is to provide a description of the physical user interface of the DS2’s new
Reference Design DH10PF in-home powerline adapter.
The DH10PF powerline adapter incorporates an AC filter and a rear socket. The purpose of this
design is to facilitate the direct connection of the adapter to a wall power outlet without depriving the
user of the use of this outlet.
The DH10PF powerline adapter provides a link between the powerline network and a Fast Ethernet
10/100M port and an auxiliary filtered output for other appliances. The design is such that on the one
hand it avoids limiting the wall socket just for PLC purposes and on the other hand provides a
filtered socket to avoid the adverse effects of appliances connected to it.
The adapter has two buttons and two LEDs that allow the user to configure a secure PLC network
without using a computer and it will also indicate the estimated channel capacity at application layer
in the receiver adapter. The main features covered are:
• One Button Security Setup: manual configuration of Fixed AP (Access Point) and automatic
generation of an Encryption Key and a Network Identifier, used to guarantee network
security, and exchange of these keys between adapters using only one button;
• Throughput indicator: with a three-colour LED, three different levels of estimated throughput
at application layer will be shown in the receiver adapter;
• Manual factory reset.
• Stand-by mode.
The minimum firmware level including the full set of above features for DH10PF is Spirit 2.2.7.
2 Adapter Description
2.1 Front panel description
Definition Function
Power/Standby button
(ON/SBY)
Used to switch the adapter between ON and STANDBY (minimum
power consumption setting). Pressing the button again will turn on
the adapter. By default adapter is ON when plugged.
Config /Factory Reset
button
(CONFIG/F RST)
Used to implement “One Button Security Setup” and “Factory Reset”
features.
“STATUS” indication LED indicates if adapter is powered ON/OFF and shows the
application throughput level available in the link (“Throughput
Indicator”).
“AP” indication LED indicates whether the device is configured as a Fixed AP (Access
Point or master) or EP (End Point or slave).
- DH10PF User Interface Manual 1
- Corporate Headquarters 2
- IMPORTANT NOTICE TO THE USER 3
- Table of Contents 4
- 1 Introduction 5
- 2 Adapter Description 5
- AGE 6 OF 16 6
- AGE 7 OF 16 7
- AGE 8 OF 16 8
- 5 Factory reset procedure 9
- 6 Status indicator 9
- AGE 10 OF 16 10
- AGE 11 OF 16 11
- AGE 12 OF 16 12
- AGE 13 OF 16 13
- 7 Troubleshooting Guide 14
- 8 Safety advise 14
- 9 Abbreviations 15
- HANTZ + PARTNER 16
Related products and manuals for PowerLine network adapters Comtrend Corporation Powerline PowerGrid DH-10P
(14 pages)American-weigh-scales-aws AL-311 manuals
Owner’s manuals and user’s guides for Scales American-weigh-scales-aws AL-311.
We providing 1 pdf manuals American-weigh-scales-aws AL-311 for download free by document types: User Manual
Comments to this Manuals