Comtrend Corporation Powerline PowerGrid DH-10P User Manual download pdf (Page 7)

DH10PF User Manual

Design of Systems on Silicon PAGE 7 OF 16

MG-TI-C2-WISC-DH10PF USER INTERFACE MANUAL-1.1

Buttons:

Button Meaning

ON/SBY Powers the adapter OFF (STANDBY) and powers it ON.

CONFIG/F RST Configuration button when pressed 2 seconds. Also performs a

factory reset when pressed for more than 8 seconds.

2.2 Rear and lower connections

The following photograph shows the power plug and LAN connections.

Power plug

LAN

Connector Definitions:

Power plug: Power supply and powerline connector

LAN: 1x RJ-45 LAN10/100 Ethernet port

3 Installing Powerline Adapters

To connect each powerline adapter to a computer or other device (Set Top Box, DSL router, etc.),

follow the steps listed below:

1. Connect the supplied Ethernet cable to the LAN port of the adapter and the other end to the

Ethernet port of the device;

2. Plug the powerline adapter into any AC electrical outlet. After a few seconds it will be up and

running.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

Comtrend Corporation Powerline PowerGrid DH-10P User Manual Page 7